Limewash Stucco and Concrete in Bellevue

Typical cost in Bellevue

  • One wall or garden wall, about 300 sq ft$1,000 – $2,400+
  • One-story stucco house, about 1,500 sq ft$5,500 – $12,000+
  • Two-story stucco house, 2,000–2,500 sq ft$7,000 – $18,000+

Stucco, block and poured concrete can trade a flat painted look for a softly clouded, plaster-like surface, on house walls, garden structures and basements. Clean, sound cement-based surfaces are porous enough to accept it. All three are surfaces we limewash here at Bellevue Limewash Painting.

Each of these soaks up limewash differently and has its own texture, so we start by checking the wall and brushing a trial patch on it. We do this in Bellevue and nearby Eastside cities, including Clyde Hill, Medina, Redmond, Mercer Island, Sammamish, Newcastle and Issaquah.

Request a free quote

Stucco cottage finished in warm sand-colored limewash

Stucco and concrete limewash options

Cement stucco exteriors

Smooth and sand-finish stucco pick up a gentle tonal drift under limewash, and bare or previously limewashed stucco is the easy case. Hairline cracks should be repaired so water stays out from behind the finish.

New stucco

An even, cloud-soft color on new stucco takes patience; limewash applied too soon can dry patchy. How long to wait is set by the product and by the state of the stucco. One maker gives about 21 to 28 days on new Portland cement stucco, and others set their own wait.

Concrete block and cinder block

A plain block garage, foundation or garden wall can end up looking like weathered masonry rather than utility construction. The block faces and the mortar take up liquid unevenly, which is why a scrubbed-in base coat and then a top coat give the steadiest color.

Poured concrete walls

Indoors or out, poured and board-formed concrete can soften toward a stone-like tone. Curing compounds, sealers and form-release residue all reduce absorption, so we clean the wall and test its absorption before sampling.

Basement and garage walls

A limewashed masonry basement wall looks brighter and still breathes, since the traditional finish does not trap moisture behind a film. It cannot hold back active leaks or hydrostatic pressure, though; the water problem has to be fixed first.

Close view of soft clouded limewash texture in raking light

Is your stucco or concrete ready?

We check for cracks, hollow-sounding patches, efflorescence, old coatings and water-repellent sealers. Acrylic and elastomeric coatings both stop absorption, but they are handled differently. Sound acrylic paint may be primed and limewashed over, if the limewash maker has a primer for it. Elastomeric coatings are another matter: some makers rule them out, and they usually have to come off first.

Like brick or stone, a stucco facade turns out evenly only if we coat it in mild, dry weather and keep the new finish from rain and strong sun until it has cured.

Looks that suit stucco

Stucco texture comes alive in warm sand, chalk and pale clay; outbuildings and garden walls carry deeper earth colors well. We brush sample boards with the same texture to show how much movement your wall will have.

Request a free limewash quote

Tell us the finish you have in mind, what the wall is made of (stucco, block or poured concrete), any paint or sealer already on it, and the address. We'll get back to you soon with an estimate or any questions we have. Estimates are free and there's no obligation.

Call (425) 696-6402

Call (425) 696-6402